Cut Sheet

CP5.121
CP
-Series
12V, 10A, 120W, SINGLE PHASE INPUT
Aug 2021 / Rev. 1.2 DS-CP5.121-EN All values are typical figures specified at 230Vac, 50Hz input voltage, 12V 10A output load,
25°C ambient and after a 5 minutes run-in time unless otherwise noted.
www.pulspower.com Phone [phone] Germany
19/28
19. A
PPROVED
,
F
ULFILLED OR
T
ESTED
S
TANDARDS
IEC 61010
-2-201
CB Scheme Certificate
Electrical Equipment for Measurement, Control and Laboratory Use -
Particular requirements for control equipment
UL
61010-2-201
UL Certificate
Listed equipment for category NMTR - Electrical Equipment for
Measurement, Control and Laboratory Use - Particular requirements
for control equipment
Applicable for US and Canada
E-File: E198865
IEC
62368
CB Scheme Certificate
IEC 62368-1 Audio/video, information and communication technology
equipment - Safety requirements
Output safety level: ES1
ATEX
Agency Certificate (Bureau Veritas)
EN 60079-0 Explosive atmospheres - General requirements
EN 60079-7, EN 60079-15 Equipment protection by type of protection
"e" and "n"
Certificate: EPS 19 ATEX 1 201 X
Temperature Code: T4
Type of Protection: ec nC
IECEx
IECEx Certificate
IEC 60079-0 Explosive atmospheres - General requirements
IEC 60079-7, IEC 60079-15 Equipment protection by type of protection
"e" and "n"
Certificate: IECEx EPS 19.0078X
Temperature Code: T4
Type of Protection: ec nC
Class
I Div 2
UL Certificate
Listed equipment for category NRAD - Listed equipment Industrial
Control Equipment for Use in Hazardous Locations
Applicable for US and Canada
E-File: E327416
Temperature Code: T4
Groups: A, B, C and D
IE
C 61558-2-16
Test Certificate
Safety of transformers, reactors, power supply units and similar
products for supply voltages up to 1100 V
Particular requirements and tests for switch mode power supply units
and transformers for switch mode power supply units
VDMA 24364
Paint Wetting Impairment Substances Test (or LABS-Test)
Tested for Zone 2 and test class C1 according to VDMA 24364-C1-L/W
for solvents and water-based paints