Cut Sheet

CP5.121
CP
-Series
12V, 10A, 120W, SINGLE PHASE INPUT
Aug 2021 / Rev. 1.2 DS-CP5.121-EN All values are typical figures specified at 230Vac, 50Hz input voltage, 12V 10A output load,
25°C ambient and after a 5 minutes run-in time unless otherwise noted.
www.pulspower.com Phone [phone] Germany
13/28
12. C
ONNECTION
T
ERMINALS
The terminals are IP20 Finger safe constructed and suitable for field- and factory wiring.
Input Output DC-OK-Signal
Type
Screw termination Screw termination Push-in termination
Solid wire
Max. 6mm
2
Max. 6mm
2
Max. 1.5mm
2
Stranded wire
Max. 4mm
2
Max. 4mm
2
Max. 1.5mm
2
American Wire Gauge
AWG 20-10 AWG 20-10 AWG 24-16
Max. wire diameter
(including ferrules) 2.8mm 2.8mm 1.6mm
Recommended tightening torque
1Nm / 9lb-in 1Nm / 9lb-in -
Wire stripping length
7mm / 0.28inch 7mm / 0.28inch 7mm / 0.28inch
Screwdrive
r
3.5mm slotted or cross-
head No 2
3.5mm slotted or cross-
head No 2
3mm slotted to open
the spring
Daisy chaining:
Daisy chaining (jumping from one power supply output to the next) is allowed as long as the average output current
through one terminal pin does not exceed 25A. If the current is higher, use a separate distribution terminal block as
shown in Fig. 12-2.
Fig. 12-1 Daisy chaining of outputs Fig. 12-2 Using distribution terminals
Load
+
-
Power
Supply
+ +
- -
Output
Power
Supply
+ +
- -
Output
Maximal 25A continuous
Distribution
Terminals
Load
+
-
Power
Supply
+ +
- -
Output
Power
Supply
+ +
- -
Output