Instruction manual

SOFTWARE INSTRUCTIONS
TMC-7DSP/TMC-6DSP Color CCD Camera Page 25
4.2.10 (b) Writing the Current Setting to EEPROM
The current setting can also be saved by writing the setting to EEPROM. Select “Write” -> “EEPROM”
from the menu bar (below).
The following parameters are not loaded from EEPROM upon booting up. At boot time, the back panel
mode switch controls these parameters.
• Shutter Mode and Shutter Speed
• White Balance
• Gamma
• Back Light Compensation
To read in these saved parameters from EEPROM, select “Read” -> “EEPROM” (Refer to).
4.2.11 Read Setting
Settings saved either on the PC’s hard disk as a text file or EEPROM can be loaded on the TMC-7DSP/
TMC-6DSP camera.
4.2.11 (a) Read Setting Saved On Hard Disk as a File
TMCDSP allows you to load saved settings. To load the setting, select “File” -> “Open” from the menu
bar.
4.2.11 (b) Read Setting Saved in EEPROM
You can read in the saved setting from EEPROM. Select “Read” -> “EEPROM” from the menu bar.