Instruction manual

OPERATION
Page 16 TMC-7DSP/TMC-6DSP Color CCD Camera
3.1.5 Software Control Features
Most of the TMC-7DSP/TMC-6DSP’s functions can be controlled by PC via RS-232C communication
using TMCDSP, PULNiX’s proprietary software. Below is a summary of these functions. Detailed
instructions for using the software program will be provided in Section 4, “SOFTWARE
INSTRUCTIONS,” on page 18. For cable information see 2.2.2(f) on page 8.
• Shutter Control
• White Balance Hold
• Y Gain
• Gamma
• Back Light Compensation
• Pedestal
• Aperture
• Hue Control (RYgain, BYgain, RYhue, BYhue)
• Write / Read setting to / from hard disk
• Write / Read setting to / from EEPROM
FIGURE 7. TMCDSP Software Control Panel
3.2 Board Layout and Adjustment
WARNING: For reference only. Removing the camera cover voids the
warranty.