Instruction manual

Page 34
Dual-Tap TM-4200GE AccuPiXEL Series Camera-Control Software
Introduction
6.1.3 Uninstalling the Software
To uninstall the Cam2Net series camera-control software from the control panel, follow the steps
below.
1. Open “Add or Remove Programs” in the control panel.
2. Select “Cam2Net” from the lists of the installed software.
3. Click the “Change” or “Remove” button.
FIGURE 29. The “Add or Remove Programs” utility can uninstall older software.
6.2 TM/TMC-4200GE Camera
FIGURE 30. Back of the TM-4200GE
The camera must have all cables properly connected and any required adapters installed and configured
to allow the software to perform the operations on the interface.
GigE
POWER