Instruction manual

Page 30
TM/RM/TMC/RMC-4200GE Software
GigE Series Camera Serial Commands
Command Parameter End of Cmd Description
Bit 4 Shutter Mode 0
00=Continuous Preset Shutter
01=Trigger Preset Shutter
Bit 5 Shutter Mode 1
10=Trigger Programmable Shutter
11=Continuous Programmable Shutter
Bit 6 Data Depth 0 00=8bit 01=10bit
Bit 7 Data Depth 1 10=12bit
Byte 11 Function Flag 2
Bit 0 Look-up table 0 00=Linear 01=Gamma.45
Bit 1 Look-up table 1 10=User Knee Table
Bit 2 Rsvd
Bit 3
Camera Control
Signals
0=CameraLink Connector 1=Hirose 12pin Connector
Bit 4 Rsvd
Bit 5
Trigger Signal
Polarity
0=Active Low 1=Active High
Bit 6 Dual / Signal Tap 0=Dual Tap 1=Single Tap
Bit 7
Positive / Negative
LUT
0=Positive LUT 1=Negative LUT
Byte 12 Function Flag 3
Bit 0
R Channel Auto
Fine Gain
0=Disable 1=Enable
Bit 1
R Channel Auto
Fine Offset
0=Disable 1=Enable
Bit 2 Rsvd
Bit 3 Rsvd
Bit 4
Blemish Compen-
sation
0=Disable 1=Enable
Bit 5 Rsvd
Bit 6 Password 0=Disable 1=Enable
Bit 7 Test Pattern 0=Disable 1=Enable
Byte 13, 14 (X1, Y1) Coordinate for Knee 1 (X1, Y1=H'00 - H'FF)
Byte 15, 16 (X2, Y2) Coordinate for Knee 2 (X2, Y2=H'00 - H'FF)
Byte 17, 18
Start Line of Pro-
grammable Scan Area
Start Line of Programmable Scan Area
(H'0000 - H'07FF)
Byte 19, 20
Total Lines of Pro-
grammable Scan Area
Total Lines of Programmable Scan Area
(H'0001 - H'0800)
Byte 21, 22
Shutter Speed of Pro-
grammable Shutter
Shutter Speed of Programmable Shutter
(H'0000 - H'081F)
Byte 23, 24 Vsub Voltage Vsub Voltage (H'0600 - H'0D00=7.8V - 17V)