Instruction manual

Page 28
TM/RM/TMC/RMC-4200GE Software
GigE Series Camera Serial Commands
Command Parameter End Cmd Ack. Response Description
Lookup Table
:LINR <cr> :o<cr> Set linear table
:GM45 <cr> :o<cr> Set gamma .45 table
:KNEE= X1Y1X2Y2 <cr> :o<cr>
Set knees
(X1, Y1, X2, Y2 = 00 - FF)
:NLUT X <cr> :o<cr>
Set Positive Knee or Negative Knee
(X = 0 Positive, X = 1
Negative)
:LUT? <cr> :o[lut]<cr> Inquire current LUT setting
Channel Balance
:EABL <cr> :oAB0<cr> Enable Gain Balancing
:DABL <cr> :o<cr> Disable Gain Balancing
:ABL? <cr> :oAB[X]<cr>
Check Gain Balancing Status
(X = 1 Enable, X = 0 Disable)
:ACL= X <cr> :o[AC][X]<cr>
Enable/Disable Optical Black Balancing and Inquire
Status
(X = 0 Disable, X = 1 Enable,
X = ? Inquire Status)
Vsub
:DCI= XXX <cr> :o<cr> Set Vsub (XXX = 600 - D00)
:DCI? <cr> :oDC[XXX]<cr> Inquire Vsub (XXX = 600 - D00)
EEPROM
:WRPG X <cr> :o<cr>
Write Page (X = 0 - 6) (Unlock the Password first if
writing to page 0) (Page 0 is the factory default set-
ting, Page 1 is the power up default setting)
:LDPG X <cr> :o<cr> Load Page (X = 0 - 6)
:RDPG X <cr> :o[settings]<cr> Read Page (X = 0 - 6)
:RPST <cr> :o[settings]<cr> Report Current Settings
Dual Tap Digital Video Output Order
:VDO X <cr> :o[VD][X]<cr>
Set Dual Tap Digital Video Output Order (X = A, B,
C, ?)
(A <--<--, B <---->, C <<----, ? Inquire video output
order)
Image Pre-processing
:BLC= 0 <cr> :o<cr> Set White Blemish Calibration Flag
:EBL= X <cr> :o[BL][X]<cr> Enable/Disable Blemish Compensation and Inquire
Status
(X = 0 Disable, X = 1 Enable,
X = ? Inquire Status)