Instruction manual

Page 11
TM/RM/TMC/RMC-4200GE Software
Configuring the TM-4200GE Camera
3.2.1 GUI Features
You can control the following camera functions using the integrated camera software.
• Shutter Speed and Mode
• Scan Mode
• Gain Control
• Offset Level
• Memory Pages
• LUT (Look-Up Table) Control
• 8, 10, 12-bit Selectable
• Trigger Input Location and Polarity
• Resolution Proportional Digital Zoom (RPDZ)
• Pixel Compensation
3.3 Configuring the Internal Frame Grabber
The integrated camera software updates the internal framegrabber settings automatically. Also, because
the internal framegrabber configuration is independent of the imager configuration, you can set up (that
is, “window”) the internal framegrabber separately, for example, the Image Settings tab in the
integrated camera software. This has the added benefit of reducing unnecessary traffic on the GigE
network, and freeing bandwidth for other cameras.
3.4 Modes
This section includes examples of various types of setup actions available through the camera
configuration dialog box.
3.4.1 Check the Current Camera Setting
You can manually send camera commands from the Serial Free Form tab of the Configuration window
shown in Figure 12. Use the serial port and click the CR check box. Enter :RPST and click Send to get
the current camera setting. For detailed information about the current camera setting, refer to Table 4 on
page 27.