System information

OMI 2.3.1 Release Notes
OMI 2.3.1 Release Notes 49
Multiple Monitors Not Supported Under Win98
OMI 2.3 does not support multiple-monitor configurations under Windows 98.
Manual Strobing Only Suitable for Diagnostic
Purposes on MVS-8100
Manual strobing is the initiation of strobe pulses with software when not using hardware
triggering. On the MVS-8100 family, manual strobing should be used only during
development and for diagnostic purposes. For production applications, always use
hardware triggering to initiate strobes.
Poor Performance Switching Genlocked
Cameras on MVS-8110
When you are using a MVS-8110 and switch from one genlocked camera to another, the
first acquisition from the new camera takes approximately 500 to 700 ms.
32-Bit Desktop, Can’t Display Mono and Color
Live from XC-003
If you create two views that simultaneously display color and monochrome live video
from a single Sony XC-003 camera, OMI may hang or cause a system crash.
MVS-8100C, XC-75CE, Win95/98: Master/Slave
Hangs or Reboots PC
On a system running Windows 95 or 95J or Windows 98 or 98J and using an XC-75CE
camera (CCIR format) on an MVS-8100C, if you configure one Image object as the slave
of another Image object and then acquire using either Image object (the master or the
slave), the system can hang or reboot the PC.
Calib Object
Point Calibration is Now Linear
If you use point calibration, the calibration computed is linear. If you specify point
correspondence pairs which are not perfectly rectangular, the four pixel coordinate
points may not be mapped to the exact world coordinate points you specify.