Hardware manual

Cognex MVS-8100C Hardware 3
50 Cognex MVS-8100C Hardware Manual
MVS-8100C Cameras and Camera Cables
The MVS-8100C frame grabber support the RS-170 and CCIR cameras for monochrome
image acquisition and NTSC cameras for color image acquisition listed in Table 21. Part
numbers are shown for the Cognex cables to use with each camera.
Note Your Cognex software package may not support all the cameras in
this list. Consult your software’s release notes for the latest
supported configurations for your software package.
Caution Cameras must be connected using the Cognex cables shown in this table. Using
non-Cognex camera cables could damage your frame grabber, your camera, or both.
JP10 3 2-3 Covering pins 1-2 specifies cameras 0 and 1
are monochrome. Covering pins 2-3 specifies
camera 0 is unused, camera 1 is color.
JP11 3 2-3 Covering pins 1-2 specifies cameras 2 and 3
are monochrome. Covering pins 2-3 specifies
camera 2 is unused, camera 3 is color.
JP14 2 Covered Reserved for internal use. Do not remove this
jumper.
JP15 2 Open Reserved for internal use. Do not use.
JP16 N/A N/A Not present on the MVS-8100C
JP17 2 Covered Reserved for internal use. Do not remove this
jumper.
Jumper
Block
Number
of Pins
Factory
default Purpose
Table 20. Jumper settings for the MVS-8100C
Camera Type Cognex Camera Cable
Sony XC-003 Color, RGB 300-0243
Sony DXC-390 Color, RGB 300-0243
Table 21. MVS-8100C supported cameras and camera cables