Hardware manual

2 MVS-8100L Hardware Description
Cognex MVS-8100L Hardware Manual 33
Jumper and Jack Settings for the MVS-8100L
Table 12 lists the jumpers and jacks on the MVS-8100L and describes how they are
used. To locate the jacks on the MVS-8100L, refer to Figure 10 on page 22. On the
MVS-8100L, pin 1 is to the left of all horizontal jumper blocks.
4STROBE–
5 PWR (see note on page 32)
6STSOP
7STSO
8STSOR
9 GND (see note on page 32)
10 No connect
Pin Signal Name
Table 11. Pinout of trigger and strobe header, JP4
Jumper
or Jack
Number
of Pins
Default
Setting Purpose
JP1 3 1-2 Selects source of +12 V power. With pins 1-2
covered, the MVS-8100L pulls +12 V from the
PCI bus. With pins 2-3 covered, the
MVS-8100L pulls power from an external power
source connected to jack JP2.
JP2 3 N/A Connection point for a source of external +12 V
power using the appropriate external power
cable as described in Selecting an External
Power Cable on page 14.
JP3 30 N/A Camera expansion header. Connection point
for the camera port expansion panel.
JP4 10 N/A Connection point for the trigger and strobe
expansion panel.
J5 6 N/A Do not use, Cognex use only.
Table 12. Jumper and Jack Settings