Hardware manual

1 MVS-8100L Hardware Installation
Cognex MVS-8100L Hardware Manual 13
Figure 5. Location of pin 1 of connector JP3 on MVS-8100L
Caution Failure to match up the red edge of the ribbon cable on the
expansion panel connector with pin 1 on connector JP3 of the
MVS-8100L may result in damage to a camera, the frame grabber,
or both.
7. If you are not using the trigger and strobe expansion panel, proceed to the next
step. If you are using the trigger and strobe expansion panel, Cognex P/N
800-0062, install it in an unused slot position. Connect the ribbon cable to
connector JP4 on the MVS-8100L so that pin1 on both connectors are aligned as
shown in Figure 6 and Figure 7.
Figure 6. Trigger and strobe expansion panel (P/N 800-0062)
Pin 1
JP3
Pin 1 on this connector must connect
Pin 1
to pin 1 on connector JP4 on 8100L.
DB-9F connector