Installation Manual

MorRyde Installation Instructions (#331707) — rev. 1-7-11

1. Remove the four 9/16-

12” bolts with a 13/16

socket.

2. Push restraining rods

toward center of box.

3. Slide spacer blocks

into channel.

4. Install bolt through

hole.

5. Install and tighten nut

(self locker) x 4.

6. Slide PullRite skid pad

(making sure wedge is

to rear of box) into

place.

7. Put plate in location

using two 9/16-12”

bolts opposite corners

to hold plate.

8. Align opposite corners

to restraining rods.

9. Align all 4 bolts before

tightening.

10. Tighten all 4 bolts and

torque to 85 ft. lbs.

11. Photo 11 shows a

completed installation

MorRyde Installation Instructions

PAGE 1
MorRyde Installation Instructions 1. Remove the four 9/1612” bolts with a 13/16 socket. 2. Push restraining rods toward center of box. 3. Slide spacer blocks into channel. 4. Install bolt through hole. 5. Install and tighten nut (self locker) x 4. 6. Slide PullRite skid pad (making sure wedge is to rear of box) into place. 7. Put plate in location using two 9/16-12” bolts opposite corners to hold plate. 8. Align opposite corners to restraining rods. 9. Align all 4 bolts before tightening.