Instructions / Assembly

Decorated Prelit Lamp Post Instruction Sheet
（Provided with the product)
Business Hours: Monday - Friday - 9:30 am - 4:00 pm EST PRINTED IN CHINA
2.Open fuse cover. Slide open fuse access cover on top of attachment plug toward blades.
3.Remove fuse carefully.
4.Risk of fire. Replace fuse with 3 Amp, 125 Volt fuse (provided with this product).
5.Close fuse cover: slide closed the fuse access cover on top of attachment plug.
CAUTION: To reduce the risk of overheating, replace burned out lamps promptly. Use 3.5 volt, 0.42 W lamps only.
FUSE REPLACEMENT INSTRUCTIONS：
Risk of fire. Do not replace attachment plug. Contains a safety device (fuse) that should not be removed. Discard product if
the attachment plug is damaged.
1.Unplug product from the receptacle or other outlet device. Do not unplug by pulling on cord.
FOR CUSTOMER SERVICE CALL: 1-800-311-3324
If none of the above steps corrects your problem, please contact the Customer Service Department at Puleo International,
Inc. following the steps as below:
Discard product if the attachment plug is damaged.
1.Make sure the light string is unplugged.
3.Allow bulb to cool. To remove bulb, pull bulb out of socket. (see below diagram)
2.To unplug, grasp plug and remove from the receptacle or other outlet device. Do not unplug by pulling the cord.
4.Check for loose, missing, or broken bulbs.
USER SERVICING INSTRUCTIONS:
BULB REPLACEMENT INSTRUCTIONS:
Risk of fire. Do not replace attachment plug. Contains a safety device (fuse) that should not be removed.
TROUBLESHOOTING:
If your tree does not light up, please check the following.
1.Check that all plugs are properly connected.
2.Check fuse in extension cord plug. If the fuse is burned out, please replace
it with spare fuse enclosed.
3.Check wall outlet for power.
SAVE THESE INSTRUCTIONS
PRE-LIT TREE ASSEMBLY INSTRUCTIONS:
1. Carton contains: 1 lamp post section, 1 pole with urn section.
2. Assemble the tree according to right diagram.
3. Plug the cords to standard AC outlet. Your product is ready for decoration.
8.Do not use this product for other than its intended use.
9.Do not hang ornaments or other objects from cord, wire, or light string.
10.Do not cover the product with a cloth, paper or any material not part of the product when in use.
11.The product employs overload protection (fuse). A blown fuse indicates an overload or short circuit situation. If the fuse
blows, unplug the product from the outlet. Also unplug any additional strings or products that may be attached to the
product. Replace the fuse as per the user servicing instructions (follow product marking for proper fuse rating) and check
the product. If the replacement fuse blows, a short circuit may be present and the product should be discarded.
Read and follow all instructions that are on the product or provided with the product.
3.To reduce the risk of overheating, replace burned out lamps promptly. This is an electrical product - not a toy! To avoid
the risk of fire, burns, personal injury, and electric shock it should not be played with or placed where small children can
4.This seasonal use product is not intended for permanent installation or use.
5.Do not mount or place near gas or electric heaters, fireplaces, candles or other similar sources of heat.
6.Do not secure the wiring of the product with staples or nails, or place on sharp hooks or nails.
7.Unplug the product when leaving the house, when retiring for the night, or if left unattended.
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
When using electrical products, basic precautions should always be followed including the following:
1.The product is for indoor and outdoor use.
2.To reduce the risk of fire, do not deliberately reposition either bulb or lampholder contact.