Instructions / Assembly

- 14 -
There are 2 fuses inside the plug; if they are black it means that they are burnt out.
Replace them with the spare fuses provided with the product.
If the section is has an extension cord connection, check the connection between
the plug and receptacle to ensure the connection to the receptacle is tight.
If all above steps can’t solve the problem, check the fuse in
the plug of the extension cord. There are 2 fuses in the fuse
case, one is in use, and the other is a spare. If the fuse in-use
is black, replace it with the spare one (See Figure 13).
(Figure 13)
How to replace a light set?
Locate the plug of the non-working set connected to the wiring harness. Un-wrap
the old set starting at the plug.
Plug the new light set into the wiring harness. Make sure to plug the new set in
the same location as the set that has been removed. Wrap the replacement set
on the branch as before.
Helpful Hint: Green electrical tape is used to cover the plugs for safety purposes.
Replacing a light set or fuses is the only time that the electrical tape should be
removed.
How to change fuses in a light set?
Typically fuses in light sets do not need to be changed. If a fuse is bad, it will
normally be in the wiring harness. This will then cause multiple light sets to be out.
It is highly unlike that one light set failure is due to a fuse.
Should you need to change the fuse, locate the taped plug which can be found on
the wiring harness. Unplug the light set, slide the cover on the plug to the open
position and replace the 2 fuses inside the plug. Replacement fuses are provided
with the spare bulb packet found inside the tree box.
Fuse replacement diagram – (Figure 14)
Warranty
Puleo International, Inc warrants this product against defects in material or
workmanship outlined as follows:
5 Year Limited Warranty on Artificial Christmas Tree