Product Manual

22 23
How to Set the Units
The CardioChek Plus analyzer may be shipped with preset units. If the SETTINGS menu
does not display UNITS, the analyzer is locked in preset units. The units cannot be
changed if the system has been locked. If your analyzer’s units have not been preset,
follow the steps listed below to change your units to mg/dL, mmol/L, or g/L (e.g., in the
US, the correct units for glucose are mg/dL and the units are preset to mg/dL).
1. If the analyzer is off, press either button to turn on the analyzer.
Wait for the display to read INSTALL MEMO CHIP or INSERT STRIP.
Note: If RUN TEST is displayed, go to Step 3.
2. Press Enter. The display will read RUN TEST.
3. Press Next until SETTINGS is displayed.
4. Press Enter, then press Next until UNITS is displayed. If UNITS is not shown on the
display, the units on this analyzer have been locked and cannot be changed. If
UNITS appears on the display screen, proceed to the next step.
5. Press Enter. The display will highlight mg/dL. If mmol/L or g/L is desired, press
Next until the desired units are highlighted on the display screen and then press
Enter to select.
6. The display will then read UNITS. Press Next until EXIT is displayed.
7. Press Enter to return to SETTINGS.
8. Press Next to return to RUN TEST.
How to Set the Sound
The CardioChek Plus analyzer sound has been preset to on.
To turn the sound on or o, follow the steps listed below:
1. If the analyzer is off, press either button to turn on the analyzer.
Wait for the display to read INSTALL MEMO CHIP or INSERT STRIP.
Note: If RUN TEST is displayed, go to Step 3.
2. Press Next. The display will read RUN TEST.
3. Press Next until SETTINGS is displayed.
4. Press Enter, then Next until SOUND is displayed.
5. Press Enter. The display will highlight
(on).
6. Press Enter to select sound or press Next to highlight
(off).
7. Press Enter to accept the sound choice highlighted.
8. Press Next until EXIT is displayed.
9. Press Enter to return to SETTINGS.
10. Press Next to return to RUN TEST.