Product Manual

20 21
How to Turn O the Analyzer
To turn o the analyzer, press both buttons (Enter and Next) at the same time for three
seconds. After three minutes of idle time (without a test strip or check strip inserted),
the analyzer will perform a 10-second countdown and turn o. To stop shutdown, press
either button. You can also remove the batteries to turn o the analyzer.
Setting Language
The rst time the analyzer is turned on, you will be required to set the language, date,
and time. The language menu consists of the following choices: English (ENGLISH),
Spanish (ESPAÑOL), Italian (ITALIANO), German (DEUTSCH), French (FRANÇAIS),
Portuguese (PORTUGSE), Dutch (NEDERLANDS), Chinese (中文), and
Russian (РУССКИЙ).
How to Set the Language (First-Time Use)
1. Turn on the analyzer by pressing either button (Enter or Next).
2. The display will read LANGUAGE. Press Enter.
3. ENGLISH will be displayed. Press Enter if English is desired.
4. For other languages press Next until the desired language is displayed, then
press Enter. To set the date and time, proceed to the How to Set the Date and
Time section.
How to Reset the Language
1. Turn off the analyzer.
2. Press and hold down Enter for approximately 5 seconds during the analyzer
power-up stage until LANGUAGE is displayed.
3. Press Enter. Press Enter again to select English or press
Next to scroll through the language choices.
4. Press Enter to select the desired language that is displayed.
How to Set the Date and Time
1. If the analyzer is off, press either button to turn on the analyzer. Wait for
the display to read either INSTALL MEMO CHIP (if a current MEMo Chip is not
installed) or INSERT STRIP (if a current MEMo Chip is installed).
Note: If RUN TEST is displayed, go to Step 3.
2. Press Enter. The display will read RUN TEST.
3. Press Next until SETTINGS is displayed.
4. Press Enter, then press Next until SET TIME is displayed.
5. Press Enter to display the date and the time, which is formatted as
YYYY/MM/DD and HH:MM.
6. The display will then highlight the year. Press Enter to accept the highlighted
year, or press Next to advance the year. Press Enter to select.
7. The display will then highlight the month. Press Enter to accept the displayed
month, or press Next to advance the month. Press Enter to select.
8. The display will then highlight the day. Press Enter to accept the displayed day,
or press Next to advance the day. Then press Enter to select.
9. The display default will then highlight 12H. Press Next to advance to 24H.
Press Enter to accept either 12H or 24H.
10. The display will then highlight the hour. Press Next to advance the hour. The
default setting is AM. To change from AM to PM press next to advance the
hour setting until AM switches to PM. Press Enter to accept. Now press Next to
advance the minutes.
Press Enter to accept.
11. Once the clock format has been selected, the SET TIME menu will display.
Press Next until EXIT is displayed and press Enter to return to SETTINGS.