User manual

HDBaseT Pro Extender
PTN Electronics Limited 2 www.putron.com
2. Introduction of Product Appearance
2.1 Product Appearance of TPHD403PT
Figure 1 Interfaces of TPHD403PT
No. Name Description
RS232
Serial port, 3p captive screw connector, connect with the
control terminal to control the controlled terminal, supports
bi-directional RS232 control between the transmitter
(TPHD403PT) and the receiver (TPHD403PR).
In
Link
On
Power
 In: When connected with device which supports HDCP and
works normally, this LED will keep on. If the device does not
support HDCP, the LED will blink.
 Link: Twisted Pair Link status indicator. It will keep on when
connection is successful.
 On: Used to show the working status, blinks when in normal
working state, turns off when stop working.
 Power: Turns red and keep on when power on.
IR IN&OUT
 IN: Connect with IR receiver, the IR signal received from this
port can only send out in TPHD403PR.
 OUT: Connect with IR Emitter, and the sending IR signal is
received from TPHD403PR.
24V DC
Connect with a DC 24V power adapter. (Not necessary if
TPHD403PR connects with power adapter)
HDBT OUT
To connect with the HDBaseT port of TPHD403PR by using a
single CAT5e cable (90m length in max).
HDMI IN HDMI input port, connect with an HDMI source device.
ETHERNET
Ethenet ports, when need to work in a local area network, one
of these 4 ports (both the Ethernet ports of TPHD403PT and
TPHD403PR) should be used for internet access, and the
others can be connected with computers. If they are well
connected, the yellow LED indicators on the corresponding
ports will keep blink and the green ones will keep on when