User manual

HDMI/IR/RS232 Twisted Pair PoC Extender
PTN Electronics Limited 2 www.PTN-electronics.com
2. Introduction of Product Appearance
2.1 Appearance of TPHD402PT
1) ON: Working status indicator, blink green when the device works fine, turn off when
the device stops working.
2) LINK: Twisted Pair link status indicator, illuminate green when the connection is
successful.
3) IN: HDCP compliance indicator, illuminate green when the connected device
supports HDCP and work normally; blink green when the connected device does
not support HDCP.
4) POWER LED: Illuminate red when power on.
5) HDBT OUT: Connect to the HDBT IN port of TPHD402PR with a CAT5e cable.
6) HDMI IN: Connect to HDMI source.
7) IR IN: Connect with IR receiver, the IR signal received from this port can only send
out via TPHD402PR.
8) IR OUT: Connect with IR transmitter, the sent IR signals are received by
TPHD402PR.
9) RS232: Serial port, 3-pin captive screw connector, connects with the control
terminal, supports bi-directional RS232 control.
10) DC 24V: Connect with power supply (Not necessary if TPHD402PR connects with
power).
Note: Pictures shown in this manual are for reference only, different model and
specifications are subject to real product.