User manual

HDMI/IR/RS232 Twisted Pair POC Extender
PTN Electronics Limited 2 www.PTN-electronics.com
2. Introduction of Product Appearance
2.1 Appearance of TPHD402PT
1) IR: IR receiver.
2) ON: Working status indicator of this device. When the device works fine, this green
LED will keep blinking. And it will get off when the device stops work.
3) LINK: Twisted Pair Link status indicator, green LED. It will keep on when
connection is successful.
4) IN: When connected with devices support HDCP and work normally this LED will
keep on. If devices not support HDCP, this green LED will blink.
5) POWER LED: LED indicator of power. When connect with power, red LED will
keep on.
6) TP OUT: Single TP cable connects to TP IN port in TPHD402PR.
7) HDMI IN: Connect to HDMI source.
8) IR IN: Connect with IR receiver, the IR signal received from this port can only send
out in TPHD402PR.
NOTICE: When there is IR receiver connected to this port, the port (1) will be
unavailable.
9) IR OUT: Connect with IR sender, the sending IR signal are received from
TPHD402PR.
10) RS232: RS232 connector.
11) 24V DC: Connect with power supply (Not necessary if TPHD402PR connects with
power).