User manual

DVI Video Processing Switcher 4x4
PTN Electronics Limited 11 www.PTN-electronics.com
5. Operations of the Software
5.1 Introduction of the Software
5.1.1 Installation & uninstallation
MV4 can be controlled by using the software MV4Demo.
 Installation: Copy the software files to the controlling computer, and run the
executable program MV4_v1.1.30.exe (showed in Figure 5-1).
 Uninstall: Delete all the software files.
Note: MV4_v1.1.30.exe is only used in its own given path.
Figure 5-1 MV4 Control Software—MV4Demo
5.1.2 Control connection
Ways for Software Control: MV4 provides three ways for control, includes RS232
serial port, USB interface and TCP/IP network port.
Software Activation: We can control MV4 if any of connections is connected and it is
the key point to activate the software.
Operation: Click the button Connection on the menu bar.
Figure 5-2 The popup menu of Connection
 RS232
If connected successfully, the message window on the right corner of the main
interface will show the message Connection Success. If not, a popup window will
appear with the message can’t open com.
 USB
If not well connected, a popup window will appear with the message can’t Find USB. If
connected, the message window will show the message Connection Success.
 TCP/IP
Use the network port and enter its IP address. The default IP address is 192.168.0.178,
and the port number is 4001. The message window will show the message Connect
NET Success. This IP address can be changed if necessary, for more details please
check the user manual of PTNET.