Technical data

-
21
9) Based on the coding switches shown as Figure 2, set up the
protocol used by the camera and the baud rate as per the state
according to Table 2. Check the address of the camera to see if
it is matched with that you need. If not, set the address of the
dome camera at corresponding position as per Table 1.
10) Rotate the vitreous cover on dome counterclockwise and
take it out. Note: if Fixed the Speed Dome Camera in the
aluminum alloy ball, you must take out the vitreous cover
on dome. Otherwise, it will effect picture quality. (see Figure
17)
11) Aiming the “MARK”on the ball at the notch on the pedestal,
push the ball upward to the end and rotate clockwise until it is
clicked, then mount the vitreous cover by rotating it clockwise
(as shown on Figure 18), and mount the cover plate of the
bracket at last (see Figure 19).
Figure17 Figure18 Figure19
4. The step of Middle/low speed dome installs (taking
wall-installing style as example)
1) Unpacking the carton and carefully take out the dome
camera and its attachments.
2) Rotate the vitreous cover counterclockwise and take it out.
(Figure 20)
The attention if the ball machine agreement and the address
do not use the adjustment, Then may cancel 2), 3), 4), 5), 6),