Technical data

Figure 2

b. Middle speed and low speed dome

Figure 3

As shown in Figure 2,3, SW1 is used to set address of the dome

camera from 1 – 1023. The coding switches from DIP-10 to DIP-1

are equivalent to a 10-bit binary digital. DIP-10 is MSB while DIP-1 is

LSB. The state “ON”of each bit means 1 while “OFF”means 0.

Following table shows states of coding switches of some addresses.

States of Coding SwitchesDome

Address

DIP-1 DIP-2 DIP-3 DIP-4 DIP-5 DIP-6 DIP-7 DIP-8 DIP-9 DIP-10

1 ON OFF OFF OFF OFF OFF OFF OFF OFF OFF

2 OFF ON OFF OFF OFF OFF OFF OFF OFF OFF

3 ON ON OFF OFF OFF OFF OFF OFF OFF OFF

4 OFF OFF ON OFF OFF OFF OFF OFF OFF OFF