Technical data

-
10
edit by CLOSE button. Operations under edit state can be seen
later.
2.6.5 SET PATROL: to edit data for multi-points patrol. Select no. of
patrol by PAN LEFT/PAN RIGHT, enter into edit by OPEN
button and exit edit by CLOSE button. Operations under edit
state can be seen later.
2.6.6 RUN PATROL: to run multi-points patrol function. Select no. of
patrol by PAN LEFT/PAN RIGHT, run and exit by OPEN button.
2.6.7 RECORD PATTERN: This pattern can consist of any standard
pan and tilt or lens command. Preset, flip, digital zoom,
proportional pan, and turbo are not allowed in a pattern. The
pattern length is 40 seconds in maximum. To return when 40
seconds expire or by push CLOSE button.
2.6.8 RUN PATTERN: to self-learn loci of tour. To exit the menu after
running or to stop running by joystick.
2.6.9 RETURN: return to Main Menu.
3. Appendix to the Menu
3.1 Operation of Edit State of Multi-Points Patrol.
When entering into edit state the screen displays as follows:
NO –Serial No. of patrol position
POS –No. of preset position
SP –leaving speed
TM –dwelling time
After entering into edit area, screen shows as
follows:
Edit Area, data of 2 patrol position appears on
one line.
SEQ:01–It means the set No.1 patrol
CLOSE: EXIT–Push CLOSE to exit edit state