User's Manual

1. Slide the SIM Card holder under the edge of the WORKABOUT PRO case until it meets the
inside of the SIM Card slot :
Power connector
2. Align the 100-pin expansion connector and the header pins on the expansion module with the
expansion connector and the header connector on the main logic board of the WORKABOUT
PRO.
3. Align the four mounting tabs on the expansion module with the four screw holes in the internal
frame inside the WORKABOUT PRO :
4. Apply slight pressure above the 100-pin connector to snap the module into place.
5. Remove the scanner flex cable from the WORKABOUT PRO.
6. Tuck the antenna cable through the frame.
7. Remove the antenna screw indicated in the Figure below before inserting the GPRS antenna.
April 07, 2010
DPD A00515 A00 Sheet 2 of 12