User manual

Enter Configuration Exit and Save
Ì$+;Î
DATA FORMAT
Ì$
-
?Î
76
CHARACTER REPLACEMENT
 disable character replacement
ÌEO0mÎ
This parameter allows up to three characters to be replaced from the barcode read. These
substitutions are stored in memory. To define each character replacement:
 Read one of the following character replacement codes:
first character replacement

ÌEO1pÎ
second character replacement

ÌEO2sÎ
third character replacement

ÌEO3vÎ

From the Code Identifier Table in Appendix B, read the Code Identifier for the desired code
family.
0 = character replacement will be effective for all code families.
 From the Hex/Numeric Table read two characters corresponding to the Hex value
(00-FE), which identifies the character to be replaced. For Wedge and USB-KBD interfaces, it
is also possible to read the Special Key(s) on page 73.
 From the Hex/Numeric Table read two characters corresponding to the Hex value
(00-FE), which identifies the new character to replace. For Wedge and USB-KBD interfaces,
it is also possible to read the Special Key(s) on page 73.
FF = the character to be replaced will be substituted with no character, that is, it will be removed
from the code.