User manual

POWERSCAN
™
D8330/M8300
34
5.
Read the BC-8060 restore default code:
Restore BC-8060 Default
Ì$+RX0$-qÎ
6. Read the desired Enable Network code.
Enable RS-485 Master
Ì$+RZ2$-ÇÎ
Enable RS-485 Slave
Ì$+RZ1$-~Î
END of procedure.
For Host Master Network Layouts (see section 3.2), The network configuration
parameters can be changed through STAR-Link™ software running on the PC.
Star-Link™ software can be downloaded free from the original manufacturer’s web
site: www.scanning.datalogic.com.
For BC-8060 Master Network Layouts (see section 3.2), The network configuration
parameters can be changed either through the original manufacturer’s Datalogic
Aladdin™ configuration software running on the PC or by reading the barcode
selections in the Network section of this manual starting on page 63. If using
configuration barcodes, it is advised to completely configure the cradles before
reconfiguring the PowerScan
™
M8300 reader (see below).
After completing the BC-8060 cradle configuration and connections in the
network, you must reconfigure the PowerScan
™
M8300 reader using the
STAR-System™ procedure in section 4.6.
NOTE