User manual

POWERSCAN
™
D8330/M8300
24
4 CONFIGURATION
4.1 CONFIGURATION METHODS
4.1.1 Reading Configuration Barcodes
This manual can be used for complete setup and configuration of your reader by
following the setup procedures in this chapter (see section 4.2 for an overview).
If you wish to change the default settings, this manual provides complete
configuration of your reader in an easy way.
To configure your reader:
Print Appendix C with the hex-numeric table and keep it open during the device
configuration.
Read the Enter Configuration code ONCE, available at the top of each page of
configuration.
Modify the desired parameters in one or more sections following the
procedures given for each group.
Read the Exit and Save Configuration code ONCE, available at the top of each
page of configuration.
Reference notes describing the operation of the more complex parameters are given
in the References section.
4.1.2 Using the Original Manufacturer’s Datalogic Aladdin™
The original manufacturer’s Datalogic Aladdin™ is a multi-platform utility program
providing a quick and user-friendly configuration method via the RS-232/USB-COM
interface.
It also allows upgrading the software of the connected device (see the original
manufacturer’s Datalogic Aladdin™ Help On-Line for more details).
4.1.3 Copy Command
A previously configured device (Master), can be used to send its configuration directly
to other devices of the same type (Slaves). The particular procedure for each device
is given in section 5.14.