Installation Guide

Figure 2
3. Attaching the GPS/HSPA+ End-Cap
• Run the cables (x3) and scanner/imager flex cable through the opening at the top of the expansion back cover.
• Using a Torx T10 screwdriver and the four screws provided (M3 x 6 mm), secure the GPS end-cap to the expansion
back cover. Torque to 5 in-lb (0.56 N-m).
4. Reassembling Omnii
• Before reattaching the back cover, connect the pistol grip trigger/speaker wire harness to socket J11 on the main
logic board. Connect the camera flex cable to socket J9 on the main logic board.
• If a scanner/imager flex cable is present in the end-cap, connect it to socket J13 on the main logic board as shown in
Figure 3. If no cable has previously been installed in this socket, there may be a piece of “dummy” stiffener that must
be removed before inserting the cable.
• Make certain the GPS bypass cable is connected (see Figure 2 on the previous page).
Figure 3
• Fit the back cover in place against the main housing, ensuring that no cables are caught in the seal.
• Using a Torx T10 screwdriver, tighten the eight screws (M3x6 mm) to a torque of 5 in-lb (0.56 N-m). Install the screws
in the sequence shown in Figure 1 on the previous page to ensure a consistent seal around the opening.
• Using a Torx T6 screwdriver, replace the two screws (M2x8 mm) above the display on the front of the unit. Torque to
2.5 in-lb (0.28 N-m).
• Through the scanner pod opening, use small needle-nose pliers to route the grey GPS antenna cable under the two
metal cable restraints on the left side of the GPS module.
• Press the grey GPS antenna connector into the socket labelled GRY on the left side of the unit. Snap it into place.
• Through the scanner pod opening, use small needle-nose pliers to route the black HSPA+ radio antenna cable under
the metal cable restraint at the top of the radio module.
• Press the black HSPA+ antenna connector into the socket labelled BLK on the radio module. Snap it into place.
•Press the green diversity cable connector into the socket labelled GRN.
• Affix regulatory label 1004434.
• Reattach the blanking plate using a Torx T10 screwdriver and four screws (M3x5 mm) to 5 in-lb (0.56 N-m).
• Install the battery.
100-pin connector
Torx T6 screws (x3)
GPS bypass cable
J13
J9
J11
Flip latch open Insert cable Flip latch closed
GPS antenna
connector
HSPA+ antenna
connector
Metal cable restraint
Diversity antenna
connector
Affix regulatory label here
COMPANY HEADQUARTERS SUPPORT SERVICES
Psion Inc. For local support services, go to:
2100 Meadowvale Boulevard, Mississauga http://www.psion.com/service-and-support.htm
Ontario, Canada L5N 7J9
Tel: [phone]
Fax: [phone]