User manual

Chapter 4: 8580/8590 Installation
Cable Cover, Grounding Bar & Cables – Assembling
8580/8590 Vehicle-Mount Computer User Manual 41
• Next, prepare the corresponding number of sealing rings. Do this by making an inci-
sion with a knife at the mark (only to the midpoint of the sealing rings).
• Make certain that the remaining sealing rings are not cut open!
• Put the correct sealing rings around the cables.
3. Fit cables to the 8580/8590.
• Connect all required cables (maximum 6) to the computer interface.
• Place the 8580/8590 onto a soft base.
4. Prepare cables and cable cover.
• Position the cable cover for mounting, slightly away from the computer.
• Loosely place the cables in loops in the cable sockets of the cable cover, not in a
straight-through position, but transposed, (see diagram). At this point, push the
sealing rings into the cable sockets.
5. Fix grounding plates and insert sealing plugs:
• Lightly fix the cables in the cable cover using the earthing plates.
• Test the fit of the cable cover relative to the equipment.
• Release the cables from the sealing rings so that the silicone can be applied.
Important: The surface of the touchscreen should always be kept free of dirt, dust,
finger marks and s on to ensure full visibility of the display. Make sure the
screen does not get scratched or otherwise damaged before placing the
device face down.