User manual

Chapter 8: Internal Devices
Touch (Serial) for Windows XP & XP Embedded
116 8580/8590 Vehicle-Mount Computer User Manual
4-wire touchscreens (10.4" front panel) and also 8-wire touchscreens (12.1" front panel) are
supported.
Resources
By default the resources for the touchscreen controller are the same as those for the COM4
port. If the appropriate configuration exists, these may also be the same as for the PS/2
mouse. With the exception of ensuring that the jumpers are set correctly J6 (open = Touch
active) and J13 (closed=PS/2, open=COM4), no further configuration is required.
8.7.1 Touch (Serial) for Windows XP & XP Embedded
8.7.1.1 Installation
By default, the touch drivers to be used can be found on the Compact Flash or hard drive
under Util/atouch/<verNR>. In addition, you will find the drivers on the driver CD shipped
with your unit.
1. Open the corresponding folder and run Setup.exe.
2. In the Welcome dialog, tap Next.
3. In the Software License Agreement window, choose I accept all of the terms of the
above License Agreement, and then tap Next.
4. In the Select Controller dialog, choose serial (RS/232) and tap Next.
5. In the Serial Configuration dialog, choose COM4 and 9600 Baud and tap Next.
6. Deselect the option on the Configuration Complete dialog and close by tapping
Finish.
7. Two Files Needed windows will appear querying the path to the tsufiltr.sys file.
8. Select Browse to navigate to the installation folder indicated above, then choose the
Serial folder and tap OK.
9. Confirm the final message Setup is now complete by tapping OK.