User manual

Chapter 2: Basic Checkout
Advanced Tab
20 NEO Hand-Held with Windows Mobile 6.1 User Manual
2.4.4 Advanced Tab
If you prefer to use Wireless Zero Config, the Windows native supplicant, to configure the
radio:
• Tap on the Advanced tab, and tap on the checkbox to the left of Use Windows to con-
figure my wireless settings to add a check mark and activate this option.
•Press [FN/BLUE][ENTER] to reset NEO.
• A dialog box lets you know that you will lose all unsaved data. Tap on OK.
Once the reset is complete, the Wireless Zero Config screen is displayed on NEO.
The following radio and security options must be defined: SSID, Auth Type, EAP Type and
Encryption.
2.5 Checking The Scanner
If your hand-held is equipped with an internal scanner, you can test it to ensure that it is op-
erating properly. Point the scanner window at a bar code that your scanner was designed to
decode. Press the [SCAN] key or the pistol trigger, and check for a valid decode on the
hand-held screen.
Performance is improved if you disable all unneeded bar codes in the Bar Codes screen.
Review Appendix C: “Bar Code Settings” for details about bar codes.
2.6 Data Transfer Between the PC & the Hand-Held
Data transfer options vary slightly depending on the type of operating system installed in
your PC. Microsoft® ActiveSync® is PC connectivity software that can be used to connect
Tap here to add a checkmark
to activate the Windows radio
configuration.