User manual

NEO Hand-Held with Windows Mobile 6.1 Classic User Manual B-1
APPENDIX B
TEKLOGIX IMAGERS APPLET
The Teklogix Imagers applet is used to create, modify, delete and activate imager
settings. The principal uses of the applet are to decode bar codes and to capture
images. A Demonstration Application is provided to demonstrate how the imager
works. Refer to “Imager Demo” on page 89 for details.
B.1 Required Applets
In order to configure imaging, the Manage Triggers must be present in the Set-
tings>System tab along with the Teklogix Imagers applet.
B.2 Presets
There are two methods that can be used to configure an imager using the Teklogix
Imagers applet:
• Use a predefined preset.
• Create a custom preset based on a predefined preset.
A preset is a group of exposure and image correction settings. Each preset config-
ures the imager for a specific purpose such as bar code decoding or image capture.
Presets also allow easier and faster configuration of the imager after power-on or
resume from suspend.
The predefined presets are generic and satisfy most user requirements. A custom
preset can be created for a specific user application, such as: include only
specified bar codes, read only a specified number of bar codes or for reading
unusual media.
Every preset belongs to a preset type. The following preset types are available:
Important: It is strongly recommended that a predefined preset is used
whenever possible. Each predefined preset contains a coherent
group of settings that are known to work together in the intended
environment. In almost all situations, at least one of the prede-
fined presets results in a satisfactory outcome.