User manual

Chapter 6: Settings
Beam
NEO Hand-Held with Windows Mobile 6.1 Classic User Manual 177
Tapping on any of these icons displays an associated notification bubble with information
about and access to the missed call(s) or voice message(s).
6.36 Beam
If your unit is equipped with an IrDA end-cap, tapping on Beam allows you to enable
Receive all incoming beams so that your unit can accept incoming data from other
IrDA devices.
6.37 Bluetooth Setup
Bluetooth is a global standard for wireless connectivity for digital devices and is intended
for Personal Area Networks (PAN). The technology is based on a short-range radio link that
operates in the ISM band at 2.4 GHz. When two Bluetooth-equipped devices come within
range of each other, they can establish a connection. Because Bluetooth utilizes a radio-
based link, it does not require a line-of-sight connection in order to communicate.
Switching On the Bluetooth Radio
Before pairing a headset or any other Bluetooth device with NEO, make certain that the Blu-
etooth device power is enabled and that the radio is switched on; it is enabled by default. If,
for some reason, it has been disabled:
• Tap on Start>Settings>System tab and then, tap on the Power icon to display the
Power dialog box.
• Tap on the Built-in Devices tab, and tap in the checkbox next to Enable Bluetooth.
• Next, tap on Start>Settings>Connections tab>Bluetooth icon.
• Tap on the Mode tab, and check Turn on Bluetooth. Tap OK.
• Turn your Bluetooth device on and place it within a few feet of NEO.
Note: The Bluetooth radio uses an internal antenna.