User's Manual

185Dialling
Dialling phone numbersDialling phone numbers
Dialling phone numbersDialling phone numbers
Dialling phone numbers
To dial a number already entered in the Contacts
program, or in a Data or Agenda file:
1. Highlight the entry you want to dial from.
2. Press the Fn and Menu keys together, or tap the Dial
button on the Toolbar in Contacts. The netBook will find up
to five numbers in each entry.
3. Select the number you want to dial, and hold the netBook
loudspeaker near to the telephone mouthpiece,
approximately 2 inches (5 cm) away.
• Press the Dial button to dial the number.
• If you wish to use the dial out code, press the Dial out
button to dial the number preceded by the dial out code.
• You can change the number if it is not correct.
• If you need to dial additional digits, press the Free input
button to make the netBook dial the DTMF codes as you
type each number.
To dial using free input dialling: press the Ctrl key with the Fn
and Menu keys, then dial the number in the ‘Free input’ dialog.
You can use the digits 0...9, *, and #. Press the Redial button to
redial the number if necessary.
Note: The preset tone and delay times will normally be fine for
dialling, unless you are using a poor quality telephone line. If
dialling doesn’t work in a particular location, try increasing the
value of the ‘Tone time’ and ‘Delay time’. Tone, Delay and Pause
times are measured in units of 1/32 seconds.