User manual

Wall Mounting
Quick Reference Guide 7
Figure 5. Inclined Base Wall-mounting
6. Attach the cradle on the base by sliding it along the mounting tabs
until aligned.
7. If mounting the BC-80X0 cradle, insert the antenna in the appropri-
ate hole on the body of the cradle and screw it clockwise until tight.
If using the adhesive strips:
3. Carefully clean the adhesive
strip seats of the base to
remove any impurities that
could reduce adhesion.
4. Remove the protective plastic
from one side of the adhesive
strips and stick them onto the
base surface.
5. Remove the plastic from the
other side of the strips and
affix the base to the wall as
indicated in the figure below.
If using mounting screws:
3. Using the mounting holes on
the base as a pattern, mark
the wall where you desire to
mount the BC-80X0.
4. Drill the appropriate size
holes and insert the threaded
dowels (not provided) into the
holes.
5. Position the base on the wall
as indicated in the figure
below and affix it by means of
the screws (not provided).