User manual

Psion Teklogix 7535/7530 Hand-Held Computer User Manual 59
Chapter 3: Getting To Know Your 7535/7530
Connecting & Disconnecting Tethered Peripherals
Scanning A Bar Code
• Turn the hand-held on. Wait until the unit has booted up completely.
• Aim at the bar code and press the scan key or the trigger. The beam
expands, covering the bar code to properly scan it. The scan beam and a
warning indicator are visible until a successful decode is achieved or three
seconds have elapsed.
Note: The SE923 scanner is not equipped with a targeting dot.
3.9 Connecting & Disconnecting Tethered Peripherals
Tethered peripherals such as scanners and printers connect to the hand-held
computer with a quick release, circular connector. When a peripheral is connected to
the hand-held, the unit detects the peripheral and loads the necessary drivers for it.
An icon in the taskbar at the bottom of the screen provides a visual representation of
the peripheral and indicates that it is ready for operation.
To attach the peripheral to the round, tether port on the side of the unit:
• Insert the barrel of the plug into the tether port and rotate slowly until
it clicks into place. The red dot on the port and on the connector should
be aligned.
Figure 3.10 Attaching The Cable To The Tether Port