User manual

Psion Teklogix 7535/7530 Hand-Held Computer User Manual 31
Chapter 2: Basic Checkout
Changing Network Properties
2.3.3.3 Changing Network Properties
To change the properties of an existing preferred network:
• Highlight the network that you want to modify.
• Tap on the Properties button.
• Make any necessary changes in the Wireless Properties dialog box, and
press <ENTER> to save the changes.
2.4 Checking The Scanner
Note: Details about operating and troubleshooting scanners and RFID readers
are provided under the heading “Internal Scanners” on page 53.
If your 7535/7530 is equipped with an internal scanner, it will successfully decode
most 1D bar codes as delivered. Press the SCAN button and check for a valid
decode on any UPC bar code. If desired, set the Dot Time parameter to zero in the
Teklogix Scanners applet in the Control Panel to turn off the default aiming dot.
Performance is improved if you disable all unneeded bar codes in the Bar Codes
screen. Review “Scanner Properties Setup” on page 150 for details about bar codes.
2.5 Using Microsoft® ActiveSync®
ActiveSync® – Microsoft PC connectivity software – can be used to connect the
hand-held to PCs running this software.
Note: Keep in mind that you’ll need to run the USB Setup program to
configure your workstation before connecting the 7535/7530 via USB.
For information about the USB application, refer to Appendix D: USB
Setup Application.
By connecting the 7535/7530 to a PC with a cable and running ActiveSync on the
PC, you can:
• View 7535/7530 files from Windows Explorer.
• Drag and drop files between the 7535/7530 and the PC in the same way that
you would between PC drives.
• Back up 7535/7530 files to the PC, then restore them from the PC to the
hand-held again, if needed, and so on.
To install ActiveSync, follow the step-by-step instructions provided with the
program’s setup wizard. Refer to the following website for details:
http://www.microsoft.com/windowsmobile/resources/downloads/pocketpc/activesync35.mspx