User manual

Appendix B: RD7950 Integrated UHF RFID Reader (7535 Only)
Installation
B-2
Psion Teklogix 7535/7530 Hand-Held Computer User Manual
Attaching The Pistol Grip
Note: A Phillips head screwdriver is required. Do not use adhesives such
as Loctite to secure the screws. These chemicals may damage the
plastic casing.
The pistol grip is attached to the back of the 7535 hand-held computer using the four
threaded inserts in the upper part of the 7535 casing. Four black #4-40 Phillips head
screws are provided with this accessory.
Note: Prior to installation, make certain the trigger mechanism is securely
snapped into the pistol grip body and that the trigger operates properly.
• Position the pistol grip so that it fits snugly over the back of the unit and the
inserts on the back of the 7535 align with the holes in the pistol grip.
• Using a Phillips screwdriver, securely fasten the pistol grip to the back of
the 7535. Tighten the screws to a torque of 3kgf-cm (3 lbs-in), or until
finger-tight, to secure the pistol grip in place.