User manual

Chapter 6: Tekterm Application
Host Conn.
286
Psion Teklogix 7535/7530 Hand-Held Computer User Manual
Auto Term#
Note: “Auto Term#” is available when 802.IQv2 is assigned to the “Host
Conn” parameter (page 286) or when
802.IQv1 is enabled in the Radio
Menu (see “802.IQ v1” on page 253).
When this parameter is set to “Y”, a unique unit number is assigned for the current
TESS session. If “Auto Term#” is set to “Y”, any value assigned to the “Terminal #”
parameter is ignored.
Group
When “Auto Term#” is set to “Y”, the ‘Group’ parameter is used to identify the
group or pool of numbers from which an auto-address is chosen.
Terminal #
For every application session you create, the “Terminal #” assigned must be
non-zero and unique. This parameter defines the terminal number for the TESS
session and uniquely identifies all transmissions to and from the 7535/7530.
Other applications running in the 7535/7530, such as an ANSI session or another
TESS session must each have a different number. In addition, each Psion Teklogix
7535/7530 using the radio link must have a unique number.
6.19.2.1 Host Conn.
Conn Type
The options for this a parameter vary depending on the type of application you are
running – ANSI or TESS.
For TESS applications, this parameter allows you to choose one of the following
types of connections:
802.IQv2, 9010t (TCP Direct), 2392/Telnet,
3274/Telnet and 5250/Telnet.
Group 1 1-5
Range
Auto Term#
Conn Type 802.IQv2 see text
Settings » see text
RangeHost Conn