User manual

Psion Teklogix 7535/7530 Hand-Held Computer User Manual 253
Chapter 6: Tekterm Application
Radio Parameters
• Press <F1> to display the ‘Radio’ sub-menu.
• Press <F1> to access the ‘802.11’ sub-menu.
• Set ‘802.IQ v1’ to ‘Y’ to activate these parameters. and press <F1> to
display ‘802.IQ v1’ parameters.
802.IQ v1
When 802.IQ v1 is set to “Y”, the attached sub-menu of parameters is enabled.
Auto Radio Addr
If this parameter is enabled, a request is sent to the network controller to assign a
radio address to the hand-held computer radio.
If “Auto Radio Addr” is set to “N”, the value entered in the “Radio Address”
parameter is used. (Refer to “Radio Address” in this section for details about
manually assigned radio addresses.)
Important: Ensure that all 7535/7530s grouped in the system use the same
addressing process – that is, if you choose to use automatic
radio addressing, use this addressing process for all units
operating in the same system. If you choose to assign radio
addresses manually using the “Radio Address” parameter, use
this process for all units in the same system.
Radio Address
The value entered in the “Radio address” parameter is used to identify the
7535/7530 over the radio link. A unique value from 1 to 3840 must be assigned
for each hand-held computer.
802.11 »
03
Radio
802.IQ v1 N »
04
802.11 DS SS
Auto Radio Addr Y Y/N
Radio Address 0 1-3840
Initial RTT 0 0-1000
Protocol Type 2457 1501-65535
Range
802.IQ v1
05