User manual

Chapter 5: Configuration
Changing A Host
202
Psion Teklogix 7535/7530 Hand-Held Computer User Manual
5.11.4.2 Changing A Host
To change an existing host IP address:
• Highlight the IP address you want to alter in the Permitted Hosts tab, and
then choose the Change button.
A dialog box like the one displayed when you add a host is displayed.
• Make the necessary changes, and press <ENTER>.
5.12 Wireless WAN
A 7535/7530 equipped with a GSM/GPRS or CDMA/1xRTT radio provides wide
area networking capabilities.
5.12.1 Taskbar Icons
Wireless WAN icons in the taskbar indicate the status of your wide area network
connection. Note that these icons are only visible when a GSM/GPRS or
CDMA/1xRTT radio is installed in the unit, and the interface is enabled.
The letter in the signal strength icon (G for GSM/GPRS and X for CDMA/1xRTT)
indicates that a packet data service is available and initialized. Keep in mind that the
signal strength icon is displayed without a letter if packet data service is not
available or if it is available but not yet initialized.
User interaction is required (e.g. the user is required to enter a PIN).
A non-recoverable (fatal) error has occurred.
The modem status is unknown or the modem is not connected to a network (the
signal strength is 0%).
Signal strength is between 1% and 20%.
Signal strength is between 21% and 40%.
Signal strength is between 41% and 60%.
Signal strength is between 61% and 80%.
Signal strength is between 81% and 100%.