User manual

Chapter 5: Configuration
Protocol Tab
144
Psion Teklogix 7535/7530 Hand-Held Computer User Manual
5.9.3 Protocol Tab
Figure 5.68 Protocol Tab
Enable Cellular Protocol
The value assigned to this parameter must be identical to the value assigned to the
corresponding parameter in the Psion Teklogix Network Controller, Wireless
Gateway or Base Station. A warm reset of the 7530 is required before this parameter
can take effect.
If Enable Cellular Protocol is disabled (unchecked), the options in the Cellular
Radio Address frame are displayed in grey text indicating that they cannot
be accessed.
Cellular Radio Address
Auto Radio Address
If Auto radio address is enabled, the 7530 requests an automatically assigned radio
address. Manual radio address is displayed in grey text indicating that it cannot
be accessed.
Manual Radio Address
The value entered in the Manual Radio Address parameter is used to identify
the 7530 over the radio link. A unique value from 1 to 3840 must be assigned for
each unit.
Note: This parameter is set to ‘0’ (an out-of-range value) by default to block
radio communication when the unit is initially powered up. This prevents
several new hand-helds from attempting to communicate with the same
default terminal number at initial power up. Once the default value is
changed, it cannot be set back to ‘0’.