Specifications

5. Install the Psion Teklogix PCMCIA Expansion Module kit, model WA9101-G1 (not included) in the
WORKABOUT PRO. This provides the connector for the PCMCIA Card.
Figure 3 The WORKABOUT PRO With The PCMCIA Expansion Module Installed
6. Slide the PCMCIA Card, with the label facing up, into the PCMCIA slot until it is fully seated:
Figure 4 Inserting The Radio Card
7. Connect the antenna cable to the connector on the right of the RFID card:
Figure 5 Connecting The Antenna
8. Insert the mechanical stop so that the antenna cable protrudes through the gap:
Figure 6 Attaching The Mechanical Stop
9. Tighten the 4 screws of the mechanical stop to a torque of 2 lb-in (0.23 N·m).
Use a #1 Phillips screwdriver.
Installed PCMCIA Expansion Module
Backplate Removed To Show PCMCIA Connector
Radio Card
Radio Card
Antenna Cable
Antenna Connector
Mechanical Stop
Antenna Cable
Antenna Connector
Screws (4 places)
April 15, 2008
8100171 Rev. A Sheet 2 of 3