User guide

PingerPro User Guide

Psiber Data Systems Revision 1.00

Getting Started

Turn on the PingerPro by pressing the power button until the screen lights up, and then release the

button. The unit displays the welcome screen for approximately 10 seconds and then the Home Screen

automatically displays.

Copper Home Screen Fiber Home Screen

The Home Screen has Auto Test, Ping, Cable Test, Setup and Help Buttons.

• Auto Test tests the network with configured parameters selected from the Setup screen.

• Ping is a quick but powerful test that, while in factory default setting, sends a Ping from the tester

to the Gateway from any part of the network. The Ping test can be quickly changed to pre-

configured profiles to Ping other devices.

• The Cable Test tests the physical copper portion of the network by measuring the length of the

cable to a short or open, performing a wiremap analysis for incorrect wire connection, sending a

tone for traceability or sending a signal to blink the switch port specific LED.

• The Fiber Test displays the power detected from the device attached to the fiber SFP port.

• Setup allows the user to customize settings for the Auto Test and the Ping test to test specific

network parameters.

• The Help button displays step-by-step instructions on how to use the PingerPro and displays the

quick start guide.