User guide

PingerPro User Guide
35
Psiber Data Systems Revision 1.00
Port ID is used to determine which port of a hub or switch is wired to a particular wall jack by blinking the
Link LED on the port. The blink rate is adjustable for compatibility with most switches and hubs. Select the
rate at which the LED will blink SLOW, MEDIUM, FAST, or VERY FAST.
Port ID Screen
Select the Tone button with the < arrow to return to the Main Cable Test Screen or select the bottom Port
ID button to send a signal to the attached Port.
Fiber Test
The Cable Test button on the Home Screen will become the Fiber Test if it’s a PingerPro 75 devices and
the fiber button was selected in Setup under the Link Screen. The Fiber Test continuously measures
and displays the Received (RX) and Transmitted (TX) power from the fiber SFP port. The sample count
and the minimum, average and maximum power detected are also displayed.
Home Screen Main Fiber Test Screen