User guide

PingerPro User Guide
13
Psiber Data Systems Revision 1.00
Ping List
The Ping List screen allows the user to select the devices the PingerPro will ping. Select one target, or
any combination of targets from the list. The options are Gateway, DHCP Server, IP Range (user
defined), or up to nine separate User Defined Targets (Ping List Entries). GATEWAY allows for the
pinging of the established gateway. DHCP SERVER allows for the pinging of the established DHCP
Server. Select the
∨
arrow to display more targets.
Setup Ping List Screen Setup Ping List 2 Screen Continuous Ping Error Message
The IP Address Range is used to ping a user defined range of IP Addresses or a whole subnet. Select
the Gray button to set the range. Select the Subnet button to select the whole subnet the PingerPro is
connected to or select Set Start IPv4 to set a specific range within that subnet. A numerical keyboard will
be displayed to enter in the starting IP Address. Enter in the desired IP address and select OK to set the
IP Address. Do the same for Set End IPv4 address. Select the Save button to save the configuration.
Setup Ping List-IP Range IP Range Setup Dialog Box Numerical Keyboard