User guide

PingerPro User Guide

Psiber Data Systems Revision 1.00

Ping

Ping is a network tool used to test whether a particular host is reachable across an IP network. There are

two options; Single or Continuous. When selecting Continuous, there can only be one ping target

device selected and it only works in Ping Test.

Select the Jumbo button to send a jumbo size frame ping packet for either single ping or continuous

pings. Jumbo allows for a ping packet payload to be 2K bytes large.

(Future Release)

Single will ping a device the number of time you select in Count. Count determines the number of times

to ping a device. Selecting the Count Button will display a numerical keyboard screen, allowing the user

to change the parameter. After entering a valid number, select OK to return to the PING screen. Select

the Save button to save the configuration.

Setup Ping Screen Numerical Keyboard

Payload is the amount of data sent with the ping packet in bytes. Select the Payload button to display a

numerical keyboard. After entering a valid number between 56 and 1518 bytes, select OK to return to the

Ping screen.

Timeout is the amount of time the PingerPro waits before a ping response returns. Select the Timeout

button to display a numerical keyboard. After entering a valid number, select OK to return to the Ping

screen.

Interval is the amount of time the PingerPro waits before sending out another ping packet. Select the

Interval button to display a numerical keyboard. After entering a valid number, select OK to return to the

Ping screen.

Select the Ping button with the

< arrow to return to the Main Setup Screen or select the bottom Ping List

button to continue on to The Ping List Setup Screen.