User`s guide

7
Compound Bow
USER’S GUIDE
Stage 3™
CAM ADJUSTMENTS
STANDARD ONE CAM
Draw Length: To change the draw length in 1” increments, the cam
must be changed. See your local PSE dealer for information on how
to obtain a replacement cam. For minor changes in draw length, the
bow must be placed in a suitable bow press and tension relieved
from the string and cable. Moving the string to the post that will
shorten the effective length of the string will shorten the draw length
by ½”. Moving the string to the post that will lengthen the effective
length of the string will lengthen the draw length by ½”.
NRG PLUS™
Draw Length: To change the draw length in 1” increments, the
module must be changed. See your local PSE dealer for information
on how to obtain a replacement module. For minor changes in draw
length, the bow must be placed in a suitable bow press and tension
relieved from the string and cable. The string side of the cam has
three posts. Moving the string from the post with the dot to the post
with the “+” will increase draw by approximately ¼”. Moving the
string from the post with the dot to the post with the “-” will decrease
draw by approximately ¼”.
Draw Stop: The position of the draw stop must match the size of the
module. For example, if the cam is equipped with a number 7
module the draw stop must be placed in one of the draw stop holes
marked with a “7”.
Let-Off: Let-off adjustment is part of the draw stop. To adjust from 80%
to 65% let-off, remove the draw stop from the 80% hole and reinstall it
in the 65% hole of the corresponding the module number. For
example, if the cam is equipment with a number 7 module the stop
must be reinstalled in the hole marked “7” in the row marked “65%”
NRG™ HYBRID CAM:
Draw Length: To change the draw length in 1” increments, the modules
must be changed on both the top and bottom cams. See your local PSE
dealer for information on how to obtain replacement modules. For minor
changes in draw length, the bow must be placed in a suitable bow press
and tension relieved from the string and cable. Move the string to the
“+” post on the top cam to increase the draw by approximately 3/8” or
to the “-“ post to decrease the draw by approximately 3/8”. The Short
Draw cams have the “+” post only. Moving the string to the “+” post will
increase draw by approximately 3/8”.
Draw Stop: The draw stop is located on the bottom cam and is
attached with two screws. It must be placed in the position that
corresponds with the modules. For example, if the cams are equipped
with number 7 modules, the draw stop must be secured firmly with
the two mounting screws in the number “7” holes.
Let-Off: The let-off adjustment is part of the draw stop. To adjust
from the factory setting of 80% to 65%, remove both screws that hold
the stop to the cam and flip it over so the cable will contact the side
marked “65%” at full draw and reinstall the screws. Note: Changing
the let-off from 80% to 65% shortens the draw by approximately 3/8”
STAGE 3™:
Draw Length: The draw length is adjusted by placing the bow in an
appropriate bow press and relieving the tension from the string and
cables. Move the string to the slot that will shorten the effective
length of the string to shorten the draw length by ½" per wheel.
Move the string to the slot that will lengthen the effective length of
the string to lengthen the draw of the bow by ½" per wheel.
NRG™ Hybrid Cam
TOP
NRG Plus™
Standard One Cam
NRG™ Hybrid Cam
BOTTOM