User`s guide

6
Compound Bow
USER’S GUIDE
Installation of Accessories
Arrowrest/Overdraw: The arrowrest or overdraw
should be installed according to the instructions received
with the product. It is usually mounted to the riser in the
threaded hole on the side opposite the shelf (hole "A")
using the hardware provided with the arrowrest or
overdraw.
Sight: The sight should be installed according to the
instructions received with the product. It is usually
mounted to the riser in the threaded holes (holes "B") on
the side opposite the shelf using the hardware provided
with the sight. Some bows are equipped with multiple
sight mounting holes which allow the sight to be moved
up or down.
Stabilizer: The stabilizer should be mounted according
to the manufacturer's recommendation. It is usually
mounted in the threaded hole on the front of the riser
(hole "C").
Bow Sling: The bow sling attaches to the riser of the
bow generally with the stabilizer. If a stabilizer is not
used, attach the sling to the riser with the correct sized
bolt using the hole provided for the stabilizer (hole "C").
Other Adjustments
Draw Weight: Your bow is factory-set to within 2 lbs. of
the peak draw weight indicated on the label on the lower
limb of the bow. Changes in draw weight can be made
by turning the limb bolt in or out. Before making any
changes in weight, turn the limb bolt clockwise until it no
longer moves. Never use extreme torque when turning
the bolt or damage to the limb may occur. The limb bolt
then may be turned counterclockwise to obtain the
desired weight, but NEVER more than 4 turns or
revolutions. Adjust each limb exactly the same.
CAUTION: On some bow models, the limb bolt locking
screw MUST be loosened BEFORE adjusting.
Wheels/Cams: Many PSE wheels and cams have
adjustable features. Each one comes from the factory set-
up and ready to use but there may be occasions where
you need to adjust the characteristics of your bow. In
some cases you will need a PSE Tune Chart to determine
what to adjust, and you may need to see a PSE Dealer
for information. If you are not sure of the adjustment you
are making, stop and see your PSE Dealer for assistance.
In all cases, an appropriate bow press will be needed to
make adjustments to cams and wheels. If you do not
have an appropriate press, see your PSE Dealer.
Hole
A
Holes
B
Hole
C
Your Authorized PSE Dealer is supplied with technical information on PSE bows and cams.
Please see your Dealer for assistance when making these adjustments.